strange problem s facing like the "task"

[velocity.jacky]

from the last couple of days i m trying to repair c 111 both cpu"s 6010 and 11oo both are connecting well , hault well , reset well , but a little bit problem in target go and also reading well but error " in writing

1. ram access memory fail

2.initialising hardware fails

3.no response from riff box 0*45

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.28, JTAG Manager Version: 1.37
Selected Resurrector: [Micromax C111 (QSC1100)]

Connecting to the dead body...OK
Set I/O Voltage reads as 1.80V, TCK Frequency is RTCK
Model selected: MICROMAX - Micromax C111 (QSC1100)

Detected dead body ID: 0x122CE0E1



Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.28, JTAG Manager Version: 1.37
Selected Resurrector: [Micromax C111 (QSC1100)]

Halting target...OK
STATUS: Target was already halted.

R0 = 0x00000005 R6 = 0x00000005 R12 = 0x58020000
R1 = 0x00000AAA R7 = 0x00000002 R13 = 0x5800BEF0
R2 = 0x000000D0 R8 = 0x58013DA0 R14 = 0xFFFF4248
R3 = 0x00000005 R9 = 0x00003E18 R15 = 0xFFFF024C
R4 = 0x00000000 R10 = 0x00000BA4 CPSR = 0x200000D3
R5 = 0x00004ECB R11 = 0x00000000
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.28, JTAG Manager Version: 1.37
Selected Resurrector: [Micromax C111 (QSC1100)]

Connecting to the dead body...OK
Detected dead body ID: 0x122CE0E1 - CORRECT!
Set I/O Voltage reads as 1.80V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz]
Settings Code: 0x0900010000800000000000000020

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...FAILED
ERROR: RAM memory selftest failed.


also change ground to many other places in the board but still the problem is same
pls guide senior members regarding this

best regards
jacky chang