supporters please - GSM-Forum

hamidoo · 05-20-2015, 19:10

hello friends and supporters i need a bit of help ....

i have this i9192 the clients bring to me stuck on the kies recovery screen . so i tried to flash but didnt work then i said i need to repair bootloader and see if it will fix that . so i opened the phone soldered the wires and everything went fine . but the phone doesnt power on after riff-box finished its job ??? so any help please experts ??

here is the log :

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Package: [I9192 MK4 Total Repair V1.00 by <legija>]

Connecting to the dead body...OK
Detected dead body ID: 0x308A30E1
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0100 (SEM08G, 0x0001D2000000 Bytes = 7.28 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0045/0x0100 (SEM08G, 0x000000200000 Bytes = 2.00 MB)

Flashing the dead body...OK
Resurrection complete!

05-20-2015, 19:10	#1 (permalink)
hamidoo Freak Poster Join Date: Feb 2007 Location: MARS Posts: 272 Member: 444981 Status: Offline Thanks Meter: 45	supporters please hello friends and supporters i need a bit of help .... i have this i9192 the clients bring to me stuck on the kies recovery screen . so i tried to flash but didnt work then i said i need to repair bootloader and see if it will fix that . so i opened the phone soldered the wires and everything went fine . but the phone doesnt power on after riff-box finished its job ??? so any help please experts ?? here is the log : Open serial port...OK Connecting to the RIFF Box...OK Firmware Version: 1.37, JTAG Manager Version: 1.56 Selected Package: [I9192 MK4 Total Repair V1.00 by <legija>] Connecting to the dead body...OK Detected dead body ID: 0x308A30E1 Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz] Resurrection sequence started. Establish communication with the phone...OK Initializing internal hardware configuration...OK Uploading resurrector data into memory...OK Starting communication with resurrector...OK Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0100 (SEM08G, 0x0001D2000000 Bytes = 7.28 GB) Detected an Initialized FLASH2 Chip, ID: 0x0045/0x0100 (SEM08G, 0x000000200000 Bytes = 2.00 MB) Flashing the dead body...OK Resurrection complete!