Toshiba Portehe G900 & RIFF Box ?

[Ivangnr]

Hello!

Can I make a phone support Toshiba Portehe G900 ?

Sincerely.

[Ivangnr]

Hello!

Can I make a phone support Toshiba Porte[FONT=verdana,geneva,lucida,'lucida grande',arial,helvetica,sans-serif]g[/FONT]e G900 ?

Sincerely.

[underbird_gsm]

for me not work maybe some buuug
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.20, JTAG Manager Version: 1.28
Selected Resurrector: [Toshiba G900 PDA]

Connecting to the dead body...OK
Detected dead body ID: 0x79265013 - CORRECT!
Set I/O Voltage reads as 2.99V, TCK Frequency is 12 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip ID: 0x0400/0xFBFF (128MB)
Flashing the dead body...OK
Resurrection complete!
but when i try to enter in update mode usb or card update ,not show me red display

[underbird_gsm]

after this operation , all ok but
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.20, JTAG Manager Version: 1.28
Selected Resurrector: [Toshiba G900 PDA]

Connecting to the dead body...OK
Set I/O Voltage reads as 2.99V, TCK Frequency is 12 MHz
Model selected: TOSHIBA - Toshiba G900 PDA

Detected dead body ID: 0x79265013

[Dens_1]

Originally Posted by underbird_gsm

for me not work maybe some buuug
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.20, JTAG Manager Version: 1.28
Selected Resurrector: [Toshiba G900 PDA]

Connecting to the dead body...OK
Detected dead body ID: 0x79265013 - CORRECT!
Set I/O Voltage reads as 2.99V, TCK Frequency is 12 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip ID: 0x0400/0xFBFF (128MB)
Flashing the dead body...OK
Resurrection complete!
but when i try to enter in update mode usb or card update ,not show me red display

Excuse me for my English.

I want help you .

Resurrection has one error = at this time the phone has no boot mode

You most flash this file with settings as on a picture Settings.jpg.
After that phone is in bootable condition, that is, even if it does not start up normally, you can flash it using known flashing methods.


http://rapidshare.com/files/454484365/bin_doc.rar

[kay_pencenk]

please help me pinout toshiba portege g900 & file fullflash,my phone has no boot mode....