eMMC direct connection problem [Answered]
 

Hello medusa team i have a problem with repair dead boot asus zenfone 2 z00ed when i press connect button to medusa pro i had this error when i connect without gnd i wont see any error

https://pasteboard.co/HQuFuAA.jpg

https://pasteboard.co/HQuFFuU.jpg

https://ibb.co/DDmzfjY

https://ibb.co/K5x18zj

Hello.

The problem is with the soldered wires. At first check correctness of pinout. Then re-solder attentively and carefully all necessary wires, make each of them as short as possible, check shorts between eMMC contacts and between soldered wires and try connect again.

so these connections should come on the emmc chip not the points shown on the medusa app picture(its shown in the mother board)

No, everything must be done according to the Software manual and according to the pinout picture.