GSM-Forum - Easy JTAG FRP MOTO G4 XT1640/1643/XT1626

GSM-Forum (https://forum.gsmhosting.com/vbb/)

- Easy-Jtag / Easy-Jtag Plus (https://forum.gsmhosting.com/vbb/f672/)

- - Easy JTAG FRP MOTO G4 XT1640/1643/XT1626 (https://forum.gsmhosting.com/vbb/f672/easy-jtag-frp-moto-g4-xt1640-1643-xt1626-2255002/)

Easy JTAG FRP MOTO G4 XT1640/1643/XT1626

thx, but where is the vcc N Vccq..

How is it the procedure?

Quote:

Originally Posted by umarmsn (Post 12655791)

Any one tested ?

.

yes , 1000% tested by myself in two phones.

Quote:

Originally Posted by toninhosantos (Post 12658553)

yes , 1000% tested by myself in two phones.

Thanks for tested report

Quote:

Originally Posted by toninhosantos (Post 12658553)

yes , 1000% tested by myself in two phones.

Quote:

Originally Posted by umarmsn (Post 12658556)

Thanks for tested report

Ok Buts its very heard work.......:confused:

moto frp ready for moto service center not posible all box and dongle waste my time go to moto service center only 20 minuts ready my mobile...charge only 300rs:mad::mad::mad::mad:

For vcc and vccq use usb cable.

Quote:

Originally Posted by toninhosantos (Post 12666089)

For vcc and vccq use usb cable.

https://s26.postimg.org/5ta85a58p/2017-08-31_215040.png

tested done

alguien tiene el pinout completo?
v3.3?
v1.8?
ya solde los pinouts de data0, gnd, cmd y clk
ayuda!

Z3X EasyJtag Software ver. 2.5.0.8

Loading eMMC Addon Firmware... IO: 1850 mV
Box S/N: 10FFC008211B940E, ,FW Ver.: 01.58
CMD Pullup Level:1722 mV
CMD Active Level:1804 mV
Box IO Level:1850 mV
CLK Rate:14000 khz
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.

In emmc voltage use 3.3v.

backup dump xt1621??