i9300i

[nagesss]

Compression is ON
Z3X EasyJtag Software ver. 3.2.0.0
Loading eMMC GEN1 Firmware... IO: 3300 mV
Box S/N: 0500801DBB914D6B, ,FW Ver.: 01.63
CMD Pullup Level:2124 mV
CMD Active Level:3083 mV
Box IO Level:3300 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------

eMMC CID : 5A5A00000000000000000000000001FA
eMMC CSD : 3C3C0000000000000000000000FFFF30
eMMC Manufacturer ID: 5A5A00 , OEM ID: 0000
eMMC Date: 00/1998 Rev.0x0
eMMC NAME: , S/N: 0
eMMC NAME (HEX): 202020202020
EMMC ROM1 (Main User Data) Capacity: 0 MB
EMMC ROM2 (Boot Partition 1) Capacity: 0 kB
EMMC ROM3 (Boot Partition 2) Capacity: 0 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 0 kB
EMMC Permanent Write Protection: Yes
EMMC Temporary Write Protection: Yes
EMMC Password Locked: No
Extended CSD rev 1.0 (MMC 4.0)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x00
Device NOT support partitioning feature
Device cannot have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: _ 0_20180920_1413.extcsd
Blocks Reading Error (0x0 , 1 , Reason: CMD Timeout Error )
mmc_read_blocks(0x200 > 0x4 ), Read address is invalid
Warning! Read error 0 strange behavior now likely!
mmc_read_blocks(0xFFFFFFFFFFFFFE00 > 0x4 ), Read address is invalid
Warning! Read error 0 strange behavior now likely!
Partition table scan:
GPT: not present
Done.

....................can this emmc be repaired
thanks