oppo a3s pattern unlock fail
 

oppo a3s pattern unlock fail


Z3X EasyJtag Software ver. 3.6.1.9
Loading eMMC GEN2 Firmware... IO: 1800 mV
Box S/N: 00DE01C70DA4A9B7, ,FW Ver.: 02.44
CMD Pullup Level:1542 mV
CMD Active Level:1876 mV
Box IO Level:1800 mV
CLK Rate:1000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------

eMMC CID : 150100514536334D4203F996DE20A56D
eMMC CSD : D02701320F5903FFF6DBFFEF8E40400D
eMMC Manufacturer ID: 0015 , OEM ID: 0100
eMMC Date: 10/2018 Rev.0x3
eMMC NAME: QE63MB , S/N: 4187414048
eMMC NAME (HEX): 514536334D42
IC Name: Samsung , KMQE60013M-B318/16GB @BGA221
EMMC ROM1 (Main User Data) Capacity: 14910 MB , 0x1D1F000 pages , 0x3A3E00000 bytes
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
RPMB Info mmc_init Error, Reason: CMD Timeout Error
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG: 0x38] Boot from:ROM1 (Main User Area)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x38.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00004000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Writing Recovery Command to MISC (35)
mmc_write_blocks(0x2FB00000 , 1000 ), Failed: CMD Timeout Error
Done.

help me to unlock

CMD Timeout error - bad connection, command to unlock not sended

but check emmc ok
read soft partition ok

how to solved this problem

how to solved this problem




check vccq and vcc or insert cc cable

CMD Timeout error - check CMD connection or CMD resistor damaged