FIRST and ONLY in the WORLD zte S518 and movitel M6105

[haidar2]

zte S518 and movitel M6105 all DONE
thanks SIGMA TEAM

SigmaKey 1.22.00
219566078 Sigma dongle 1.24, Initializing...OK
SigmaKey 1.22.00 MTK: Direct unlock
USB Serial Port (COM34), Provider: FTDI, Driver ver.: 2.6.0.0, Date: 10/22/2009
Baud rate: 115200
Release "Power on" button!
Baseband Processor: MT6250, HW Rev. 1.00, SW Rev. 1.01
Serial number:
Testing external RAM...4 Mb
Detecting flash...SPI, ID: 00C22535-00000000
Flash size: 2 Mb, block size: 4 Kb
File system: 188 Kb @ 001D0000
Firmware: EASTAEON52_1632_10A_PCB01_GSM_MT6252_S01.MVT-MZ-QD-P110A19V1_0_0B03
Hardware IMEI: Not found
Software IMEI 1: 869677010967862
Software IMEI 2: 869677010967862
Mounting system disk...#0
Security area saved to "C:\Documents and Settings\Raja\My Documents\SigmaKey\security backup\869677010967862_EASTAEON52_1632_10A_PCB01_G SM_MT6252_S01_MVT-MZ-QD-P110A19V1_0_0B03 (0).skb"
Unlocking phone...Done

[matengo]

Hie
I have an mtm zte s518 from zambia how can i unlock it. Because i have sigma box but i'm faililng to unlock it. which platform and cable do you use

[GSM_Support]

@ matengo,

I have an mtm zte s518 from zambia how can i unlock it. Because i have sigma box but i'm faililng to unlock it.

First of all please post here log file from the operations you've tried to perform.

which platform and cable do you use

Double check Direct Unlock manual and perform unlock operation according to it.
In case if any error appears, post here log file.

Direct Unlock Manual

1. Connect SigmaBox / SigmaKey Dongle to PC USB port and launch SigmaKey Software
2. Go to "Unlock" tab
3. Connect* turned off phone to PC
4. Select an appropriate COM port in SigmaKey Software (usually the highest number)
5. Press "Unlock" button and follow the instructions in the log window
6. Press and hold "Power ON" button on the phone
7. As soon as SigmaKey shows an appropriate message in the log window, release "Power ON" button
8. The message "Unlock done… OK" indicates that procedure was completed successfully
9. Disconnect the handset
10. Phone is unlocked *

* MTK models have to be connected to PC COM port via original COM data cable or any COM port emulator. If you are SigmaBox owner, connect phone to PC via SigmaBox.

Also, please refer to this link for the cable pinouts.

Best Regards
GSMServer team