U100 SucessFully Unlock Done By 4SE Dongle

[.::Advance::.]

4SE - tool 2.0.4
Selected model: Kita™ (U100)
Selected operation: Unlock
Selected interface: USB (BOOTROM)
Checking USB driver status...OK (SEMC Flash Device v2.2.0.5 )
Remove battery, wait a few seconds and insert it back
Plug USB cable holding both "2" and "5" buttons
Connected to USB16
You can now release the keys and allow the process to run. Do not disconnect the phone
Device identification...OK
        Sending Preloader...OK
        Sending IDloader...OK
        Chip:DB3350 Model:U100i IMEI:35681703-279054-2 CID:53 Domain:RED
        OTP LOCKED:1 CID:53 PAF:1
Uploading logic DB3350:
        Detecting flash type...OK
                ID: 2CAA (Micron)
                Chip: Micron 2048 Mbit NAND (large page) x08
                Logical address: 0x80000000
                Size: 264 Mb
        Reading TA security data...OK
        Sending CSLoader...OK
Authenticating with key KIDP96_EMP_DUMP_R1A...OK
Reading unique device key...OK
        Device key:FEAA754BC5E793BFEECF796FBF5D3170
Restarting device...OK
Connected to USB16
Device identification...OK
        Sending Preloader...OK
        Sending ResetLoader...OK
Authenticating with key KIDP96335035...OK
Reseting to factory defaults...OK
Restarting device...OK
Connected to USB16
Device identification...OK
        Sending Preloader...OK
        Sending ProductionLoader...OK
Writing SEMCBOOT...OK
Changing certificate to RED...OK
Recompiling security area...OK
Shutting down device...OK
Operation completed successfully. You can disconnect the phone now
FINISHED [20sec]