All Blackberry Solution -:Part 2 - Page 19 - GSM-Forum

imoefi · 12-02-2011, 18:43

can you help me remove 'activation required' from my telus unlocked storm 9530 Blackberry phone ? tried ##111111 and ##000000 even tried installing UniCDMA , but it couldn't read my phone details. what to do ? frustrating.

boladas · 12-05-2011, 19:12

can u pls help me with my problem in my 8520 some keypad not working likes 2,5,8,enter ,delete,return key .... pls help...thanks in advance

boladas · 12-06-2011, 21:09

9300 lading jvm done... but when initialzing stops always pls help...

abdullah142 · 12-08-2011, 20:39

do you have mic jumper for 8520

m_ird · 12-09-2011, 06:47

hi sir with very thanks....sir i need pearl8100 vibrator ways becoz one print is damaged.

gsm st · 12-10-2011, 19:42

blackberry 9000 lcd why pls some on help me ? i have maney pcs lcd prob;lem
can some on help me how to solve this ..i have change new lcd 2,3 but no reselt
keypad light on yours pcs on but screen not sow i have change many lcds...pls give jumper why...thanks

ikhan9323 · 12-11-2011, 06:01

8900 network problm.. signal full but when i make a call so it going to network serching.. any one have idea how to fix it?

ozanah · 12-12-2011, 11:22

bb8900 stuck on startup any solution
[email protected]
thx advance

poshe142 · 12-12-2011, 20:49

i need the microfone ways por the blackberry 9650.

please help!

Serapax · 12-15-2011, 15:04

Hello, I hope someone can help me with a charging problem.

The phone starts up ok and appears to charge, but after a few minutes, underneath the keypad gets very hot.

If I let it cool down, remove the charger and put a newly charged battery in, again the keypad gets very hot as well as the battery.

This phone has had a little bit of water damage (the initial problem) and I have cleaned what I could see.

1) Where is the best place to look to fix it (which components or measurements)?

2) How do I easily remove the shielding screens?

Thanks in advance

ADEWOLE · 12-21-2011, 04:03

I need bb 9000 red blinking solution,it does not connect to pc

xiaotouqusi · 12-21-2011, 04:06

Smart Battery Analyzer for Mobile phone, PDA, Camera, and Camcorder Batteries

danilo89 · 12-21-2011, 23:29

hi can any1 please help me.

i have a blackberry 9300 curve that has been dropped in water.

when it was dropped it was still working fine but all of a sudden it dies and it is now not turning on even when i do a battery pull the red light dont show. but when i plug it in the mains chargerthe red light lights up and turns on to a picture of a battery with a red cross across it. i have tried a diff battery and still no joy, when i opened it to check the inside it looks like the main board has a scratch on it, it looks like it may be missing some component but i dont have another mainboard to compare it to. can any1 please post a zoomed in picture of a 9300 curve mainboard. please see pic for which part looks missing. thanks.

http://img708.imageshack.us/img708/5332/bb930015.jpg

Beenpkeeper · 12-24-2011, 21:45

No red light, nothing at all, not battery so would i be correct in assuming it is a fault with the Power Ic and if so, is it simply a case of resoldering or replacing and where is it located.

Hope someone can help with an answer.

BK

h5r0ld · 12-28-2011, 10:31

boss.. you have a repair for BB 8310 grounded?... thanxs much...

12-09-2011, 06:47	#275 (permalink)
m_ird Insane Poster Join Date: Feb 2009 Location: pakistan Posts: 63 Member: 967459 Status: Offline Thanks Meter: 12	pearl8100 hi sir with very thanks....sir i need pearl8100 vibrator ways becoz one print is damaged.

12-12-2011, 20:49	#279 (permalink)
poshe142 Major Poster Join Date: Sep 2010 Location: New York Posts: 39 Member: 1405801 Status: Offline Thanks Meter: 4	BLACKBERRY 9650 microfone ways i need the microfone ways por the blackberry 9650. please help!

12-15-2011, 15:04	#280 (permalink)
Serapax Junior Member Join Date: Dec 2011 Posts: 3 Member: 1705222 Status: Offline Thanks Meter: 0	BB 9700 charging problem Hello, I hope someone can help me with a charging problem. The phone starts up ok and appears to charge, but after a few minutes, underneath the keypad gets very hot. If I let it cool down, remove the charger and put a newly charged battery in, again the keypad gets very hot as well as the battery. This phone has had a little bit of water damage (the initial problem) and I have cleaned what I could see. 1) Where is the best place to look to fix it (which components or measurements)? 2) How do I easily remove the shielding screens? Thanks in advance

12-24-2011, 21:45	#284 (permalink)
Beenpkeeper Major Poster Join Date: Sep 2010 Location: Hampshire Posts: 43 Member: 1387216 Status: Offline Thanks Meter: 5	Dead 8900 No red light, nothing at all, not battery so would i be correct in assuming it is a fault with the Power Ic and if so, is it simply a case of resoldering or replacing and where is it located. Hope someone can help with an answer. BK

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I neeeeed NCDS 2.0!!!! plzz!!!!	ratzfatz	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	3	02-27-2022 22:12
Solution for GSM phones!?!?!?!?	todosije	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	6	12-16-2010 05:52
Need info for unliocking 2 lock (with pic microprocesors)	Tomas	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	06-26-1999 01:00

12-02-2011, 18:43	#271 (permalink)
imoefi Junior Member Join Date: Nov 2011 Posts: 1 Member: 1696356 Status: Offline Sonork: don al Thanks Meter: 0	can you help me remove 'activation required' from my telus unlocked storm 9530 Blackberry phone ? tried ##111111 and ##000000 even tried installing UniCDMA , but it couldn't read my phone details. what to do ? frustrating.

12-05-2011, 19:12	#272 (permalink)
boladas Junior Member Join Date: Oct 2008 Posts: 20 Member: 887494 Status: Offline Thanks Meter: 3	can u pls help me with my problem in my 8520 some keypad not working likes 2,5,8,enter ,delete,return key .... pls help...thanks in advance

12-06-2011, 21:09	#273 (permalink)
boladas Junior Member Join Date: Oct 2008 Posts: 20 Member: 887494 Status: Offline Thanks Meter: 3	9300 lading jvm done... but when initialzing stops always pls help...

12-08-2011, 20:39	#274 (permalink)
abdullah142 Junior Member Join Date: Sep 2010 Posts: 33 Member: 1393230 Status: Offline Thanks Meter: 6	do you have mic jumper for 8520

12-10-2011, 19:42	#276 (permalink)
gsm st No Life Poster Join Date: May 2005 Location: GULMI Age: 49 Posts: 2,181 Member: 143007 Status: Offline Thanks Meter: 141	blackberry 9000 lcd why pls some on help me ? i have maney pcs lcd prob;lem can some on help me how to solve this ..i have change new lcd 2,3 but no reselt keypad light on yours pcs on but screen not sow i have change many lcds...pls give jumper why...thanks

12-11-2011, 06:01	#277 (permalink)
ikhan9323 Banned Join Date: Sep 2007 Posts: 198 Member: 598249 Status: Offline Thanks Meter: 154	8900 network problm.. signal full but when i make a call so it going to network serching.. any one have idea how to fix it?

12-12-2011, 11:22	#278 (permalink)
ozanah Freak Poster Join Date: Apr 2008 Location: some where in europe Posts: 251 Member: 752357 Status: Offline Sonork: miker cellular centre Thanks Meter: 22	bb8900 stuck on startup any solution [email protected] thx advance

12-21-2011, 04:03	#281 (permalink)
ADEWOLE Junior Member Join Date: Jul 2008 Posts: 17 Member: 815495 Status: Offline Sonork: gdad Thanks Meter: 20	I need bb 9000 red blinking solution,it does not connect to pc

12-21-2011, 04:06	#282 (permalink)
xiaotouqusi Junior Member Join Date: Dec 2011 Posts: 3 Member: 1707017 Status: Offline Thanks Meter: 0	Smart Battery Analyzer for Mobile phone, PDA, Camera, and Camcorder Batteries

12-21-2011, 23:29	#283 (permalink)
danilo89 Junior Member Join Date: Dec 2011 Posts: 5 Member: 1702866 Status: Offline Thanks Meter: 1	hi can any1 please help me. i have a blackberry 9300 curve that has been dropped in water. when it was dropped it was still working fine but all of a sudden it dies and it is now not turning on even when i do a battery pull the red light dont show. but when i plug it in the mains chargerthe red light lights up and turns on to a picture of a battery with a red cross across it. i have tried a diff battery and still no joy, when i opened it to check the inside it looks like the main board has a scratch on it, it looks like it may be missing some component but i dont have another mainboard to compare it to. can any1 please post a zoomed in picture of a 9300 curve mainboard. please see pic for which part looks missing. thanks. http://img708.imageshack.us/img708/5332/bb930015.jpg

12-28-2011, 10:31	#285 (permalink)
h5r0ld Junior Member Join Date: Mar 2006 Posts: 17 Member: 247708 Status: Offline Thanks Meter: 1	boss.. you have a repair for BB 8310 grounded?... thanxs much...