Tell me any China hardwere problem.i will Try to solve it only in one hour - Page 89 - GSM-Forum

newjazzy · 01-12-2016, 10:05

helppfful man ,ppls my china nokia 105 screen display is up side down and i have check so many screen

9557123886 · 01-13-2016, 12:25

my lava kkt 29+ diply light not working pls help me urgent ?

crgeek · 01-14-2016, 05:16

Quote:

Originally Posted by crgeek

I have a Bird V1277 that I had rooted. I decided to do a factory reset on it and now it's stuck in a boot loop. First it will show 'Android' in the middle of the screen and at the bottom it says '=> RECOVERY MODE'. After a couple of seconds a robot shows up for about 2 seconds then it restarts and goes back to the 'Android' display. This loop continues indefinitely. I can get to Factory Mode by holding the power button and the Volume Up button but can't get to recovery mode. Is my Bird V1277 permanently bricked or is there something else I can try?

Thanks,
Rich

I'm going to give this a bump to see if I can get some help.

Rich

newjazzy · 01-14-2016, 15:04

please can anybody help me with itel 1404 insert sim ways,please am begging

newjazzy · 01-16-2016, 13:03

http://i66.tinypic.com/2qnqgq9.jpg

newjazzy · 01-16-2016, 13:31

pls help me the model is itel 1404 ,the sim ways is missing pls help me

2hot · 01-20-2016, 08:49

i changed spd 6531da . set no power on but when i insert charger set show charging and that time i powered on set ,set fully powered on but when remove charger set again shut it down. i chnage 3 cpu but problem not solve. those cpu run well in other phone. please help me

ghutiya ajay · 01-22-2016, 13:35

Plese give me solution or jumper solution

sooltys · 01-23-2016, 18:55

Hi my friend.

I have Huawei P8 lite after water damage (just little bit near digitizer socket) someone before me try to repair this phone and breake few parts near touch socket, i fixed this ptouchpad.rebuild bypass connections, but still no working touchpad.
Have u any schematic digitizer connector in the phone board?
Many thanks for any solution bro.

sooltys · 01-24-2016, 11:50

Inside Huawei P8 digitizer is Cytma445 IC touch controller and working perfect (i test it diffrent huawei board) , hi communicate with main microprocessor with i2c bus, i need where to connect i2c bus signal ( clock and data) to phone boardy, any suggestions?

sorry for my bad english

sahabuddin.tele · 01-29-2016, 06:50

symphony d150 down baton,5 baton,and 8 baton ar positive line nai plz help me bro.......

montaha2222 · 01-31-2016, 04:41

sir china function phone...headsphone mode still please solution

Bayode Ogundeji · 02-02-2016, 21:26

Infinix Hot Note X551 fake charging problem, please any solution?

helpful-man · 02-03-2016, 08:33

Quote:

Originally Posted by Bayode Ogundeji

Infinix Hot Note X551 fake charging problem, please any solution?

Android base phone fake charging solution is here.Charge shows but never stored.No need to change charging ic just connect a 3.6 volt zenor doid betwen battery connector + and charging connector+. Output will be +.

Enjoy

Bharat Bera · 02-28-2016, 10:25

Plz help me ssigmateS90 insert sim card

01-22-2016, 13:35	#1328 (permalink)
ghutiya ajay Junior Member Join Date: Sep 2015 Posts: 4 Member: 2452689 Status: Offline Thanks Meter: 0	mmx mic problem x321 Plese give me solution or jumper solution

01-23-2016, 18:55	#1329 (permalink)
sooltys Junior Member Join Date: Aug 2004 Age: 44 Posts: 26 Member: 78472 Status: Offline Thanks Meter: 3	P8 lite ditizer problem Hi my friend. I have Huawei P8 lite after water damage (just little bit near digitizer socket) someone before me try to repair this phone and breake few parts near touch socket, i fixed this ptouchpad.rebuild bypass connections, but still no working touchpad. Have u any schematic digitizer connector in the phone board? Many thanks for any solution bro.

01-24-2016, 11:50	#1330 (permalink)
sooltys Junior Member Join Date: Aug 2004 Age: 44 Posts: 26 Member: 78472 Status: Offline Thanks Meter: 3	P8 lite digitizer problem Inside Huawei P8 digitizer is Cytma445 IC touch controller and working perfect (i test it diffrent huawei board) , hi communicate with main microprocessor with i2c bus, i need where to connect i2c bus signal ( clock and data) to phone boardy, any suggestions? sorry for my bad english

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
news headlines to gsm phone	mos	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	7	05-22-2016 11:42
How can I do a Welcome note for my 6110 a dosn't have any one ?	Viper	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	06-27-2015 11:57
How to add a language in 51xx/61xx	tati	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	05-21-2013 19:20
How to upload a new firmware...	Brand	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	06-08-2012 18:29
Copy from one 6110 to another	Leif Nielsen	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	06-10-1999 22:36

01-12-2016, 10:05	#1321 (permalink)
newjazzy Freak Poster Join Date: Feb 2013 Posts: 187 Member: 1883473 Status: Offline Thanks Meter: 11	helppfful man ,ppls my china nokia 105 screen display is up side down and i have check so many screen

01-13-2016, 12:25	#1322 (permalink)
9557123886 Junior Member Join Date: Jul 2013 Location: gopeshwar Posts: 7 Member: 1988725 Status: Offline Thanks Meter: 2	my lava kkt 29+ diply light not working pls help me urgent ?

01-14-2016, 15:04	#1324 (permalink)
newjazzy Freak Poster Join Date: Feb 2013 Posts: 187 Member: 1883473 Status: Offline Thanks Meter: 11	please can anybody help me with itel 1404 insert sim ways,please am begging

01-16-2016, 13:03	#1325 (permalink)
newjazzy Freak Poster Join Date: Feb 2013 Posts: 187 Member: 1883473 Status: Offline Thanks Meter: 11	http://i66.tinypic.com/2qnqgq9.jpg

01-16-2016, 13:31	#1326 (permalink)
newjazzy Freak Poster Join Date: Feb 2013 Posts: 187 Member: 1883473 Status: Offline Thanks Meter: 11	pls help me the model is itel 1404 ,the sim ways is missing pls help me

01-20-2016, 08:49	#1327 (permalink)
2hot Freak Poster Join Date: Oct 2009 Posts: 242 Member: 1141307 Status: Offline Thanks Meter: 19	i changed spd 6531da . set no power on but when i insert charger set show charging and that time i powered on set ,set fully powered on but when remove charger set again shut it down. i chnage 3 cpu but problem not solve. those cpu run well in other phone. please help me

01-29-2016, 06:50	#1331 (permalink)
sahabuddin.tele Junior Member Join Date: Apr 2015 Location: bangladesh Posts: 27 Member: 2387110 Status: Offline Thanks Meter: 3	symphony d150 down baton,5 baton,and 8 baton ar positive line nai plz help me bro.......

01-31-2016, 04:41	#1332 (permalink)
montaha2222 Junior Member Join Date: Jan 2016 Location: bangladesh Posts: 2 Member: 2513534 Status: Offline Sonork: 3721530000 Thanks Meter: 0	sir china function phone...headsphone mode still please solution

02-02-2016, 21:26	#1333 (permalink)
Bayode Ogundeji Insane Poster Join Date: Jul 2011 Location: Nigeria Posts: 86 Member: 1609576 Status: Offline Thanks Meter: 14	Infinix Hot Note X551 fake charging problem, please any solution?

02-28-2016, 10:25	#1335 (permalink)
Bharat Bera Junior Member Join Date: Jun 2015 Location: Contai Age: 32 Posts: 1 Member: 2415493 Status: Offline Thanks Meter: 0	Plz help me ssigmateS90 insert sim card