Zte c s183 dead repair with riff 100%

[pocketmar]

Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.55
Selected Resurrector: [ZTE S183 V1.0.5165.40995]

Connecting to the dead body...OK
Detected dead body ID: 0x122C80E1 - IGNORED!
Set I/O Voltage reads as 1.78V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x017E/0x0063 (16MB)
Selected Resurrection Data for the NOR Chip with IDs: 0x017E/0x0063

Flashing the dead body...OK
ERROR: DCC Loader has reported Error Code = 0x2B (0x000000). Trying to recover...OK
WARNING: Programming Error (0x25) at 0x000000FE8000 is Ignored.
WARNING: Programming Error (0x25) at 0x000000FF0000 is Ignored.
WARNING: Programming Error (0x25) at 0x000000FF8000 is Ignored.
Resurrection complete!
SELECT MODLE CLICK RESERRUTION UNTICK FIRMWARE TICK EEPRON IF ANY MSG COME CLICK IGNORE 100% DONE.

[asiftak]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x017E/0x0061 (8MB)

Looking for the RIFF BOX DCCLoader USB Interface Port...FAILED
The DCCLoader USB Interface is not found. Communication continues over the DCC Interface

Writting FLASH1 memory from 0x000000000000 to 0x0000007FFFFF
ERROR: Timeout while waiting for DCC Loader response. Trying to recover...

plz solve my problem

[mediapeople]

i have also tried this but after resurrection phone not powering on only making port & suddenley disconnected