Error: 0108 in Terminator 1.8 hi, can anyone tell me what is this error for,, ie error 0108 in terminator 1.2 to terminator 2.0 actually i am trying to read codes for my t200 and after 3-4 times of blue bar going to 50% and resets,, this error comes. plz help me Naman |
weel i must tell that the phone i used (t200) was an unlocked one. may be this is the reason Naman |
I think not I readed T200 unlocked and gived me corect codes I locked back with NCK and unlocked again BR Rak|m |
error 0108 appears when terminator can't bypass boot authority (more precisely - not received expected byte sequence). Just remove battery in phone, put it in and try again - I encountered this problem many times (in fact not in T200 - most in T65) but all solved after some tries ... Good Luck |
thanx,,, will try it some more time,,,,, but now error 0101, think pic has fried, but detects dongle and dct4 also works good... dont know whats wrong now Naman |
I had error 0108 few times and always i clean phone conector and then work ok. Regards |
thnx for replying, will try it when i get a phone to work on.. Naman |
no, pin cleaning didnt worked out. well i got 1 thing the pins at phone connector that is from 1 to 12, there is continuity in pin no. 2 to pin no. 6 when i connect the dongle to lpt, otherwise no continuity. that is Rx is connected to GND when i connect dongle to lpt port, which is not practicle. i think. this might be the problem, but dont know why is it there. checked several times plz help Naman |
All times are GMT +1. The time now is 06:52. |
vBulletin Optimisation provided by
vB Optimise (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
- GSM Hosting Ltd. - 1999-2023 -