Intex Avatar2 Tab Firmware & flash tool - GSM-Forum

.::AZEEM::. · 08-27-2014, 14:11

Intex Avatar2 Tab Firmware & flash tool

Firmware upgrade procedure:

Connect charger with Tab & Tab with PC via USB cable.
Open Sherif roms installer.exe, application window
Select “FW Path” to update.img file.
Hold “volume up” (key) on tablet and Reset it via pin hole.
Windows will prompt you to install the device. Provide driver location path to USB driver > x86 / amd64 > Vista/Win7/Xp depending on OS of your PC.
After driver installation is finished, it will be shown as RK29 device inside My Computer > Manage > Devices.
Check 1st icon under Connected Devices, if it turns Green the device is ready to upgrade and driver has been installed properly, otherwise install USB driver again.
Keep holding Menu key till you see Green icon under connected devices. Then release the M key.
Click on “Upgrade” icon on bottom left side. Device upgrade will start, Green icon will turn to blinking Yellow.
Wait for the download process to finish "Success<1> Fail<0>".
Click "Exit" and disconnect USB cable.
Tab will Auto calibrate, press "OK"It will display Launcher after few minutes.

xmanwolf8 · 09-11-2014, 09:40

sir 4.1.2 jelly bean intex avatar 2 flashfile this file now working

08-27-2014, 14:11	#1 (permalink)
.::AZEEM::. No Life Poster Join Date: Aug 2006 Location: I N D I A Posts: 3,795 Member: 336212 Status: Offline Sonork: 100.1585000 Thanks Meter: 4,912	Intex Avatar2 Tab Firmware & flash tool Intex Avatar2 Tab Firmware & flash tool Firmware upgrade procedure: Connect charger with Tab & Tab with PC via USB cable. Open Sherif roms installer.exe, application window Select “FW Path” to update.img file. Hold “volume up” (key) on tablet and Reset it via pin hole. Windows will prompt you to install the device. Provide driver location path to USB driver > x86 / amd64 > Vista/Win7/Xp depending on OS of your PC. After driver installation is finished, it will be shown as RK29 device inside My Computer > Manage > Devices. Check 1st icon under Connected Devices, if it turns Green the device is ready to upgrade and driver has been installed properly, otherwise install USB driver again. Keep holding Menu key till you see Green icon under connected devices. Then release the M key. Click on “Upgrade” icon on bottom left side. Device upgrade will start, Green icon will turn to blinking Yellow. Wait for the download process to finish "Success<1> Fail<0>". Click "Exit" and disconnect USB cable. Tab will Auto calibrate, press "OK"It will display Launcher after few minutes. Intex Avatar2 Uploded By Azeem

09-11-2014, 09:40	#2 (permalink)
xmanwolf8 Junior Member Join Date: Feb 2014 Posts: 35 Member: 2134862 Status: Offline Thanks Meter: 1	sir 4.1.2 jelly bean intex avatar 2 flashfile this file now working