5065N Frp done by umt box [SUCCESS REPORT]

[sucre13]

Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Android HS-USB QDLoader 9008 (COM14)
Driver Info : TCL, qcusbser.sys, 2.1.1.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1009600 [8909] 19004200
OPK_DATA : 2797F8088CC885C0DEC627B7855AFF2F382C62688BB8802813 22C0B3581BDFCE
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8909_024.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 8 GB
LU Count : 1 [0x00E98000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 16384, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : TCL 5065N [msm8909]
Software : LMY47V release-keys, vN5S-0 [Sun Jul 17 13:17:30 CST 2016]
Android Ver. : 5.1.1
Patch Level : 2016-07-05
Resetting FRP Lock......Done
Operation Finished.
Module Ver. 2.0