zte k88 frp not done

[mysty619]

Operation : Reset FRP
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM80)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1209700 [8952] 00000400
OPK_DATA : 025843819772C7B86130317DEEFCA484196D58DA44C4702F91 7B86299A61F8CB
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8952_020.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8952, eMMC, 16 GB
LU Count : 1 [0x01D1F000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE K88 [msm8952]
Software : K88V2.0.0B15, 20170828.115541 [Mon Aug 28 11:55:34 CST 2017]
Android Ver. : 7.1.1
Patch Level : 2017-09-01
Resetting FRP Lock......Done
Operation Finished.


put in ftm mode then use tool to force it in edl mode then perform frp operation..done.