GSM-Forum - View Single Post - **MT box cables modifications, test points and pinouts**

MicrostarGSM® · 07-06-2006, 19:57

For Some new BB5 models please read this link

N80 Cable Modification

Modifcation for E61

Cable Modification For 6131,6125 and E60

For others new BB5 please check as below

Make sure the BSI to GND is 68K resistor normaly some cable comes with only 39K so you have to change to 68K

and from BSI to BSI box normaly it dosen't have you need to add either 5.1K or 7.5K , if you have put the 5.1K it not shown test mode ot local mode then use the 7.5k. Make sure the phone must be in test mode or local mode inorder to have working cable your your MT-Box

Below attachment is for others BB5 models Please Test and post result and logs for the phone info and flash log

regards

07-06-2006, 19:57	#6 (permalink)
MicrostarGSM® No Life Poster Join Date: Dec 2002 Age: 47 Posts: 4,775 Member: 18855 Status: Offline Thanks Meter: 1,938	For Some new BB5 models please read this link N80 Cable Modification Modifcation for E61 Cable Modification For 6131,6125 and E60 For others new BB5 please check as below Make sure the BSI to GND is 68K resistor normaly some cable comes with only 39K so you have to change to 68K and from BSI to BSI box normaly it dosen't have you need to add either 5.1K or 7.5K , if you have put the 5.1K it not shown test mode ot local mode then use the 7.5k. Make sure the phone must be in test mode or local mode inorder to have working cable your your MT-Box Below attachment is for others BB5 models Please Test and post result and logs for the phone info and flash log regards Last edited by MicrostarGSM®; 01-19-2007 at 13:49.