reset codes This is for the GX10 / GX10 i
don't yet know if it works on the GX20 & 30, but it just might. At worst it may just not work.
full factory reset - clears EVERYTHING
Turn phone OFF
Remove SIM
Put battery back in, but DO NOT TURN ON
1 Press 0, 3, top right key and Red key together for about 3 secs until a white display is shown.
2 Press 0, 1, 2, 3, top right key, 1, in sequence. The Diagnosis menu should be displayed.
3 Enter 99 and press the top right key. A message should be displayed saying Input Mode No:
4 Enter 1 and press the top right key. The following messages should appear:
· EE_FORMAT START
· EE_FORMAT OK
· EE_INIT(1) START
· EE_INIT(1) OK
· BBSRAM CLEAR END
· FINISHED
· PLEASE ANY KEY
5 Wait until all the above messages are displayed and then press the top right key.
6 Press the M key (very important). Message should display Diag Param Saving.
7 Press the red key to power down the phone
Default phone code will now be the standard 0000 (as when phone was new)
[Edited on 3-6-2004 by daznok]
--------------------------------------------------------------------------------
Do phones cause brain damage? Some customers are living proof ! |