V3 High Current damaged - GSM-Forum

kaino147 · 07-12-2006, 13:25

Pls i have here a moto v3 with me that is damaged by electric power supply when it was plugged for charging. Right now its no longer coming on and also it doesn't respond to usb when connected to a computer. Pls what do y'all think is the solution to this problem. I know for sure its hardware problem but don't know what part is responsible for the not coming on. Pls all suggestions are welcome. Share your ideas plsssssssssss.

Thanks in advance

masik · 07-14-2006, 09:57

V3 Charging ways ( V3 lvl3 Service manual - search)

amza · 07-14-2006, 15:40

what u have to do is put it in flash mode first. to do that, u have to press #* while the phone is off and plug in the cable. if u dont get boot loader screen it means u probably killed the PA. (power amp). if it is pa, better leave it to a pro because u have to remove shields

mamo_mogon03 · 07-14-2006, 16:14

I have v235 model, bootloader 8.0E. I did unlocking directly as P2K standard procedure using smartclip box. But it appears on screen error;80,40. Is the Model supported by the box? Please anybody could help me.

07-12-2006, 13:25	#1
kaino147 Freak Poster Join Date: Feb 2004 Posts: 319 Member: 53891 Status: Offline Thanks: 9 Thanked 6 Times in 5 Posts	V3 High Current damaged Pls i have here a moto v3 with me that is damaged by electric power supply when it was plugged for charging. Right now its no longer coming on and also it doesn't respond to usb when connected to a computer. Pls what do y'all think is the solution to this problem. I know for sure its hardware problem but don't know what part is responsible for the not coming on. Pls all suggestions are welcome. Share your ideas plsssssssssss. Thanks in advance

07-14-2006, 16:14	#4
mamo_mogon03 No Life Poster Join Date: Feb 2006 Location: No Place on Earth Like Home Posts: 559 Member: 235905 Status: Offline Sonork: 100.1580742:mamomogon03 Thanks: 127 Thanked 37 Times in 26 Posts	moto V235 please help I have v235 model, bootloader 8.0E. I did unlocking directly as P2K standard procedure using smartclip box. But it appears on screen error;80,40. Is the Model supported by the box? Please anybody could help me.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-14-2006, 15:40	#3
amza Junior Member Join Date: Jul 2006 Location: australia Posts: 6 Member: 311547 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	what u have to do is put it in flash mode first. to do that, u have to press #* while the phone is off and plug in the cable. if u dont get boot loader screen it means u probably killed the PA. (power amp). if it is pa, better leave it to a pro because u have to remove shields