Quote:
Originally Posted by khan786000  Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung I9070 V1.0.4762.51152]
Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - IGNORED!
WARNING: Embedded I/O Voltage is overriden to 2.45V
Set I/O Voltage reads as 2.48V, TCK Frequency is 12 MHz
WARNING: Reset Override to: [No RESET]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0000 (SEM08G, 0x0001D2000000 Bytes = 7.28 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0045/0x0000 (SEM08G, 0x000000200000 Bytes = 2.00 MB)
Selected Resurrection Data for the eMMC Chip with Capacity = 7.28GB
Flashing the dead body...
ERROR: DCC Loader has reported Error Code = 0x35 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x35 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x35 (0x000000). Trying to recover...OK
ERROR: Stopped due to multiple communication errors. Terminating at 0x000000000000 |
check usb driver its driver problem NTU8500 not installed
check usb cable in other port