Hi
i have connected i9000 emmc with easyjtag and saying this is not samsung emmc klmag8dedd ?
Detection Code:
Z3X EasyJtag Software ver. 2.0.0.0
Loading eMMC Addon Firmware... IO: 2800 mV
Box S/N: 0FFFF01A289C9EC3, ,FW Ver.: 01.52
CMD Pullup Level:2114 mV
CMD Active Level:2670 mV
eMMC Device Information
EMMC CID : 00000000000000000000000000000000
EMMC CSD : 902601320F5903FFF6DB7FFF96404080
EMMC Manufacturer ID: 0000 , OEM ID: 0000
EMMC Date: 00/2013 Rev.0x0
EMMC NAME: , S/N: 0
EMMC NAME (HEX): 20202020202000
EMMC ROM1 (Main User Data) Capacity: 512 MB
EMMC ROM2 (Boot Partition 1) Capacity: 0 kB
EMMC ROM3 (Boot Partition 2) Capacity: 0 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 0 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.0 (MMC 4.0)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
Backup saved: _ 0_20150404_1436.extcsd
=============================================
Extended CSD rev 1.0 (MMC 4.0)
=============================================
Searching for partition tables...
Read Pages Failed, Reason: CARD Data FIFO Timeout Error
Partitioning not detected...
Done.
Code:
Running:SAMSUNG: Read S.M.A.R.T Report...
Z3X EasyJtag Software ver. 2.0.0.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:2114 mV
CMD Active Level:2670 mV
This eMMC is not Samsung!
Done.
Code:
Running:SAMSUNG: MoviNAND Reset + Format...
Z3X EasyJtag Software ver. 2.0.0.0
Skip loading eMMC Addon Firmware
CMD Pullup Level:2114 mV
CMD Active Level:2670 mV
This eMMC is not Samsung!
Done.
i wana use thid in i9100 may be this will work this was write protected when i removed from m110s
i am unable to write i9100 bin dump file on ths emmc may be partition problem.
question is it work with i9100 or not?