Quote:
Originally Posted by kothamamun  ompression is ON
Z3X EasyJtag Software ver. 2.6.0.1
Loading eMMC GEN1 Firmware... IO: 1850 mV
Box S/N: xxxxxxxxxxx, ,FW Ver.: 01.60
CMD Pullup Level:350 mV
CMD Active Level:1557 mV
Box IO Level:1850 mV
CLK Rate:14000 khz
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done. |
Please check all connection you're log is different previous log
Z3X EasyJtag Software ver. 2.5.0.8
Loading eMMC Addon Firmware... IO: 1850 mV
Warning: CMD Pullup Level (247 mV) too low , check cables etc.!
CMD Active Level:1577 mV
Box IO Level:1850 mV
CLK Rate:14000 khz
HiPower mode is off!
Can't init device, Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]
Done.