View Single Post
Old 10-09-2017, 14:43   #57 (permalink)
Imran6364
Junior Member
 
Join Date: Aug 2014
Posts: 23
Member: 2246086
Status: Offline
Thanks Meter: 1
Z3X EasyJtag Software ver. 2.5.0.8

Loading eMMC Addon Firmware... IO: 2800 mV
Box S/N: 0404000A6F2B6423, ,FW Ver.: 01.60
Warning: CMD Pullup Level (20 mV) too low , check cables etc.!
CMD Active Level:2320 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.

help me for these problem mr.blang sir thanks in advance
  Reply With Quote
 
Page generated in 0.12708 seconds with 6 queries