| Nokia 105 ta-1034
Open VPLfile : TA-1034_059Z0X8_10.02.11.vpl
Description : TA-1034 IJ
DeviceType : TA-1034
ProductCode : 059Z0X8
SoftwareVer : 10.02.11
PPM LangPack :
[1] : Urdu (Islamic Republic of Pakistan)
[2] : English (United Kingdom)
Load Ok!
Operation : Write FirmWare [ v1.12 ]
Setting : UserData erase : True
Setting : LangPack Only : False
1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : Nokia USB Serial Port (COM20)
MODE : NOKIA USB SERIAL
PORT : 20
BROM : Init BROM
BROM init passed!
CHIP : MT6261 , SBID : 0xCB01 , HWVR : 0x8000 , SWVR : 0x0001
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : 17C3FC2A0DFCE56241394A849F160D41
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : N103.11.00.11.p1
BOOT : SWR : 11.00.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6261
AGENT : N103.11.00.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8E
NOR: 00EF : 0070 : 0016 : 0000
NOR: [Winbond] SF_W25Q32JV
NOR:
TSIZE : 0x00400000 [ 4.00 MB ]
PSIZE : 0x00400000 [ 4.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST
STATUS : OK
BSTYLE : SF_FLASH_BOOT
Boot done!
VPL SoftwareVersion : 10.02.11 [TA-1034]
DEV SoftwareVersion : 11.00.11
SWInfo compare result : VPL SW ( Minor version ) is LOWER, than in DEVICE!
Load FlashSet :
MROM : TA-1034_ROM_eMP_10.02.11
LANG : TA-1034_LANG_PACK_ROM_IJ_eMP_10.02.11_001
CUST : TA-1034_CUSTPACK_ROM_IJ_eMP_10.02.11_001
JUMP : TA-1034_JUMP_TABLE_IJ_eMP_10.02.11_001
VIVA : TA-1034_VIVA_eMP_10.02.11
Prepare FlashSet :
DCR : TA-1034_ROM_eMP_10.02.11
DCR : TA-1034_LANG_PACK_ROM_IJ_eMP_10.02.11_001
DCR : TA-1034_CUSTPACK_ROM_IJ_eMP_10.02.11_001
DCR : TA-1034_JUMP_TABLE_IJ_eMP_10.02.11_001
DCR : TA-1034_VIVA_eMP_10.02.11
Prepare Target
SDS : OK : 0x003F8000 : 0x00008000
FFS Format Ok!
Erase Target Flash
Erase done!
Write Target Flash
Write : TA-1034_ROM_eMP_10.02.11
Write : TA-1034_LANG_PACK_ROM_IJ_eMP_10.02.11_001
Write : TA-1034_CUSTPACK_ROM_IJ_eMP_10.02.11_001
Write : TA-1034_JUMP_TABLE_IJ_eMP_10.02.11_001
Write : TA-1034_VIVA_eMP_10.02.11
Write done, waiting target response ...
Write flash done!
Verify Target FlashContent
Verify : TA-1034_ROM_eMP_10.02.11
Verify : TA-1034_LANG_PACK_ROM_IJ_eMP_10.02.11_001
Verify : TA-1034_CUSTPACK_ROM_IJ_eMP_10.02.11_001
Verify : TA-1034_JUMP_TABLE_IJ_eMP_10.02.11_001
Verify : TA-1034_VIVA_eMP_10.02.11
Done!
Elapsed: 00:01:15
Reconnect Power/Cable! |