| Thank you for your replies.
@layder: But when using the latest EasyJtag version, it does not reports Password protected
Setting frequence to 21 MHz
CMD Pullup Level: 3021 mV
CMD Active Level: 1815 mV
EMMC Device Information :
EMMC CID: 0600003136FFFFFFFFFF195C493934EA
EMMC CSD: 8C4F012A0F598000F6D801E08A400076
EMMC Manufacture : , EMMC NAME: 16 , HEX: 313600000000 , S/N: 195C4939 , rev. 0xFF
EMMC Manufacture ID: 0x06 , OEM ID: 0x00 , Device Type: Device (removable) , Date: 3/2001
EMMC ROM 1 (Main User Data) Capacity: 31596 MB (0007B6C80000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 0 KB (000000000000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 0 KB (000000000000) Counter: 0 , Response: Maybe not clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.0 (MMC 4.0)
Boot configuration [PARTITION_CONFIG]: 0x00 , Boot from: no boot
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x00
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: 16_195C4939_20190627_095207.extcsd
EMMC Init completed.
Do you have any explanation?
I can try to format eMMC and write dump, but isn't eMMC linked with CPU in Xiaomi?
And eMMC can not be replaced but only together with CPU from the same mainboard?
Can EasyJtag help?
Any advice?
Thank you for help |