[project-luminol]

this chip is kmr210008m all pinouts look fine , there is any special settings for those combined chip ?

this is the log

eMMC_tool Suite ver. 1.6.2.0 (release date: 30.06.2019)
Microsoft Windows 10 (64 bit) build 18362 (10.0.18362.1)

Looking for EasyJTAG box...
EasyJTAG API ver. 3307

EasyJTAG Box Firmware = 2.44

Changelog:

30.06.2019 (ver 1.6.1.0)
Fix: Bugs that have been found through your crash report

Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit

Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 36 MHz
CMD Pullup Level: 1799 mV
CMD Active Level: 1854 mV
Can't init device. Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]

Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 36 MHz
CMD Pullup Level: 2731 mV
CMD Active Level: 2792 mV
Can't init device. Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]

Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 36 MHz
CMD Pullup Level: 3110 mV
CMD Active Level: 3277 mV
Can't init device. Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]

Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 1 MHz
CMD Pullup Level: 3111 mV
CMD Active Level: 3277 mV
Can't init device. Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]