| Nokia ta 1030 3310 2017 flash done with best
pen VPLfile : TA1030_059X9S3_11.02.11.vpl
Description : TA-1030 NDT MEA IJ GREY URDU PK
DeviceType : TA-1030
ProductCode : 059X9S3
SoftwareVer : 11.02.11
PPM LangPack :
[1] : Urdu (Islamic Republic of Pakistan)
[2] : English (United Kingdom)
Load Ok!
Operation : Write FirmWare [ v1.19 ]
Setting : UserData erase : True
Setting : LangPack Only : False
1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...
PTFN : Nokia USB Serial Port (COM13)
MODE : NOKIA USB SERIAL
PORT : 13
BROM : Init BROM
BROM init passed!
CHIP : MT6260 , SBID : 0xCB00 , HWVR : 0x8000 , SWVR : 0x0000
BROM : SECCFG : 0x00000007
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : 8852A97D9D49D0F82BF114377013FE51
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : RETRO.10.03.11_2.p1
BOOT : SWR : 10.03.11_2
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6260
AGENT : RETRO.10.03.11_2.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8B
NOR: 00EF : 0060 : 0018 : 0000
NOR: [WINBOND] W25Q128FW
NOR:
TSIZE : 0x01000000 [ 16.00 MB ]
PSIZE : 0x01000000 [ 16.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST
STATUS : OK
BSTYLE : SF_FLASH_BOOT
Boot done!
VPL SoftwareVersion : 11.02.11 [TA-1030]
DEV SoftwareVersion : 10.03.11_2
SWInfo compare result : DEVICE SW ( Minor version ) is LOWER, than in VPL!
Load FlashSet :
MROM : TA-1030_ROM_eMP_11.02.11
LANG : TA-1030_LANG_PACK_ROM_IJ_eMP_11.02.11_001
CUST : TA-1030_CUSTPACK_ROM_IJ_MEA_PK_eMP_11.02.11_001
JUMP : TA-1030_JUMP_TABLE_IJ_MEA_PK_eMP_11.02.11_001
VIVA : TA-1030_VIVA_eMP_11.02.11
Prepare FlashSet :
DCR : TA-1030_ROM_eMP_11.02.11
DCR : TA-1030_LANG_PACK_ROM_IJ_eMP_11.02.11_001
DCR : TA-1030_CUSTPACK_ROM_IJ_MEA_PK_eMP_11.02.11_001
DCR : TA-1030_JUMP_TABLE_IJ_MEA_PK_eMP_11.02.11_001
DCR : TA-1030_VIVA_eMP_11.02.11
Prepare Target
SDS : OK : 0x00FF4000 : 0x0000C000
FFS Format Ok!
Erase Target Flash
Erase done!
Write Target Flash
Write : TA-1030_ROM_eMP_11.02.11
Write : TA-1030_LANG_PACK_ROM_IJ_eMP_11.02.11_001
Write : TA-1030_CUSTPACK_ROM_IJ_MEA_PK_eMP_11.02.11_001
Write : TA-1030_JUMP_TABLE_IJ_MEA_PK_eMP_11.02.11_001
Write : TA-1030_VIVA_eMP_11.02.11
Write done, waiting target response ...
Write flash done!
Verify Target FlashContent
Verify : TA-1030_ROM_eMP_11.02.11
Verify : TA-1030_LANG_PACK_ROM_IJ_eMP_11.02.11_001
Verify : TA-1030_CUSTPACK_ROM_IJ_MEA_PK_eMP_11.02.11_001
Verify : TA-1030_JUMP_TABLE_IJ_MEA_PK_eMP_11.02.11_001
Verify : TA-1030_VIVA_eMP_11.02.11
Done!
Elapsed: 00:02:34
Reconnect Power/Cable! |