[HalooMa]

Originally Posted by aleksanchez

try this



https://ibb.co/stnVn0T

thank this pinout Working
--------------------------------

Setting interface to EasyJtag2/ISP_HiPower
Setting bus width to 1 Bit
HiPower mode is ON
Setting frequence to 24 MHz
CMD Pullup Level: 1816 mV
CMD Active Level: 1876 mV
EMMC Device Information :
EMMC CID: 45010044413431323801D6FAD507853D
EMMC CSD: D00F00328F5903FFFFFFFFEF8A404023
EMMC Manufacture : SANDISK , EMMC NAME: DA4128 , HEX: 444134313238 , S/N: D6FAD507 , rev. 0x01
EMMC Manufacture ID: 0x45 , OEM ID: 0x00 , Device Type: BGA (Discrete embedded) , Date: 8/2018
EMMC ROM 1 (Main User Data) Capacity: 119276 MB (001D1EC00000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 16384 KB (000001000000) Counter: 6567 , Response: Not Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG]: 0x08 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x02 , width 8bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: DA4128_D6FAD507_20200219_001734.extcsd
EMMC Init completed.

Operation: Reading from eMMC...

Reading from: ROM1 , start: 0x000000000000 , size: 0x000040000000
Output file: C:\Users\Helmy\Desktop\nova 3i\EMMC_DA4128_ROM1_000000000000_000040000000.bin
eMMC switching to ROM1
Reading partition...