06-23-2020, 16:59
|
#164 (permalink)
|
| Product Supporter
Join Date: Jun 2002 Location: Belarus Age: 47
Posts: 3,191
Member: 13148
Status: Offline Thanks Meter: 2,956 | Quote:
Originally Posted by juve2106  here is log easy jtag nand from lcd broken s6 edge
Setting interface to EasyJtag2/UFS
Socket Information :
Socket Mark: EasyJTAG UFS Socket BGA-95 by EasyJTAG 25.06.19
Socket Serial: 0123D2BFCB989276EE
UFS Power Information :
Mode: High, VCC: 3289mV, VCCQ2: 2799mV
UFS Device Information :
UFS Manufacturer: SKHYNIX, UFS ProductName: HBG4a
UFS OemID: 01AD, UFS SerialNumber: 0x0310538AC2C0
Maximum Number of LUs: 0, Number of LUs found: 0, Number of WLUs found: 0, LUs Re-configure: Enabled
This UFS is temporarily not supported.
UFS Init completed. |
I post link and answer you above
You need read my old answer again: Quote:
Originally Posted by layder We can't know, why this chips was be dead.
We buy some Hynix IC at china and it work fine. But chips from board was dead after some operations with it
I was wrote above: "You can check/uncheck <Disable UFS safe mode> at setting to work with Hynix UFS" | Quote:
Originally Posted by layder Quote:
Originally Posted by kamreikia This chip is temporary unsupported. | this chips can be dead after 3-5 operation with it
if you want to kill it - Quote:
Originally Posted by kamreikia disable UFS Safe Mode in options tab. | | Quote:
Originally Posted by layder Quote:
Originally Posted by html6405 Did someone ever found a solution to recover Data of this Chip?
I couldnt find any programmer which supports it. | This chips need work only at "Low" voltage
And it will be dead some next time
You need select "Low" voltage
You need select "Disable UFS safe mode" at setting
And pray to recover all Data )
Use EasyJTAG Plus software with Low voltage and Explorer
Do it faster - go to needed folder and save files
And you need return "Disable UFS safe mode" at setting to Safe mode after |
Last edited by layder; 06-23-2020 at 17:10.
|
|
|  |