Device : Xiaomi Poco F1
Operation : Reset Mi Account
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM5)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.7
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1B00800 [SDM845] 00007200
OPK_DATA : 99AF649E077EBCE3E9E187442ABDC70BD715756DE9ED192E9F 7883A10EBE09F4
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [SDM845]...Done
Executing Loader...OK
Auth Enabled Device! You need Mi Auth Account to service!
Requesting UMT Auth Service (FREE)...OK
Detecting Chip Type...OK
Hardware : SDM845, UFS, 128 GB
LU Count : 6 [0x01CA5800] [0x00000800] [0x00000800] [0x00002000] [0x00120000] [0x00002000]
Payload Info : In: 262144 [65536], Out: 262144, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi POCO F1 [beryllium]
Brand : Xiaomi
Prod.Name : beryllium
Software : PKQ1.180729.001, V10.3.8.0.PEJMIXM [Wed Sep 11 22:07:22 WIB 2019]
Android Ver. : 9
Patch Level : 2019-09-01
Resetting Mi Account Data...Done
Preparing Data...Done
Formatting Userdata...Done
When phone is completely ON, connect to Internet and add Mi Account.
-------------- INFORMATION --------------
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.
QcFire Ver. 6.0
team
nice update umt |