| Welcome to Octoplus Box Samsung software version 3.0.0
Card S/N :
-----------------------------------------------------------------------------------
To connect SM-J710F phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->More->About Device.
3. Tap on "Build number" 7 times to enable developer options.
4. Go to Menu->Settings->More->Developer options.
5. Turn on "USB Debugging" option.
-----------------------------------------------------------------------------------
To connect SM-J710GN phone you have to perform the following
steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->More->About Device.
3. Tap on "Build number" 7 times to enable developer options.
4. Go to Menu->Settings->More->Developer options.
5. Turn on "USB Debugging" option.
-----------------------------------------------------------------------------------
WorkID: 000CB618
Platform: Samsung Android
Selected port: COM1
Selected model: SM-J710GN
Operation: Reset FRP - UART EMMC
Searching for UART interface.. COM4
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...OK
Reading data...
Checking operation...OK
Searching for UART interface.. COM4
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Resetting FRP lock (1/4 attempt)..success
FRP / Reactivation lock is successfully reseted!
Performed by 3.0.0 Software version. |