[layder]

eMMC/UFS Health status is calculated by chip and does not depend on create gp1 and anothers action

these values represent the average wear on the cells in the chip.

therefore, there are always very high wear and low wear cells in the chip. their partial mixing occurs when the chip is completely erased and the data is written again.

when any cell works out its number of cycles, it becomes to read-only state. those stops erasing and writing this cells, like 0000000 address cell

gp1 partition is created at 00000000 and next adresses cells and block this cells from use as begin ROM1 address

and nothing else