| Setting interface to EasyJtag2/ISP_HiPower
Setting bus width to 1 Bit
HiPower mode is ON
Setting frequence to 36 MHz
CMD Pullup Level: 642 mV
CMD Active Level: 2023 mV
EMMC Device Information :
EMMC CID: 15010056594C30304D19B31E4BB85E61
EMMC CSD: D02701320F5903FFF6DBFFEF8A404067
EMMC Manufacture : SAMSUNG , EMMC NAME: VYL00M , HEX: 56594C30304D , S/N: B31E4BB8 , rev. 0x19
EMMC Manufacture ID: 0x15 , OEM ID: 0x00 , Device Type: BGA (Discrete embedded) , Date: 5/2011
EMMC ROM 1 (Main User Data) Capacity: 15028 MB (0003AB400000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 512 KB (000000080000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 KB (000000020000) Counter: 0 , Response: Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG]: 0x48 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x01 , width 4bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x03
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: VYL00M_B31E4BB8_20201122_184833.extcsd
EMMC Init completed.
Operation: Writing eMMC...
Writing to: ROM1 , start: 0x000000000000 , size: 0x000020000000
Input file: E:\I9100\Samsung_GT-i9100_model_dump_rom1_512mb_fixed\Samsung_GT-i9100_model_dump_rom1_512mb.BIN
eMMC switching to ROM1
Writing partition...
Error writing at address: 000000000000 , error: -8, DATA SND CRC Error(Small ROM Size, maybe) ... Retry #1
Error writing at address: 000000000000 , error: -1, CMD Timeout Error ... Retry #2
Error writing at address: 000000000000 , error: -1, CMD Timeout Error ... Retry #3
Too many errors. Writing has been stopped |