 jtag plus V2 error read emmc
hello all and team please the same one any idea my box jtag v2 without any adapter or any phone connected show me this error
Found 3 serial devices
COM87 FTDIBUS\COMPORT&VID_0403&PID_0011 USB Serial Port (COM87)
COM1 ACPI\VEN_PNP&DEV_0501 Communications Port (COM1)
COM36 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Plus Control Port (COM36)
Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 3.7.0.20
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: xxxxxxxxxxxxxxx, ,FW Ver.: 01.63
Warning: CMD Pullup Level (0 mV) too low , check cables etc.!this read lin eroor
CMD Active Level:2310 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
Can't init device, Reason: CMD Timeout Error
Done.
please anyone can guide me fix this problem |