02-22-2021, 14:03
|
#2 (permalink)
|
Product Supporter
Join Date: Jun 2002 Location: Belarus Age: 47
Posts: 3,188
Member: 13148
Status: Offline
Thanks Meter: 2,948 | Quote:
Originally Posted by aichi-gsm hello all and team please the same one any idea my box jtag v2 without any adapter or any phone connected show me this error
Found 3 serial devices
COM87 FTDIBUS\COMPORT&VID_0403&PID_0011 USB Serial Port (COM87)
COM1 ACPI\VEN_PNP&DEV_0501 Communications Port (COM1)
COM36 USB\VID_0325&PID_0032&REV_0100&MI_00 Easy Jtag Plus Control Port (COM36)
Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 3.7.0.20
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: xxxxxxxxxxxxxxx, ,FW Ver.: 01.63
Warning: CMD Pullup Level (0 mV) too low , check cables etc.!this read lin eroor
CMD Active Level:2310 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
Can't init device, Reason: CMD Timeout Error
Done.
please anyone can guide me fix this problem | this log from old box.
you message not correct
you need check you isp connection |
| |