| redmi note 10 frp done umt
Device : Xiaomi Redmi Note 10
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM20)
Driver Info : HS Corporation, ghsser.sys, 10.2104.1.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1500900 [SM6150] 00007200
OPK_DATA : 4B60244704D721E5B96DD5BB7233886E38F2198FBDE6433FCE 1D25A7B0472DD7
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [SM6150]...Done
Executing Loader...OK
Auth Enabled Device! You need Mi Auth Account to service!
Skipping Auth...OK
Detecting Chip Type...OK
Hardware : SM6150, UFS, 64 GB
LU Count : 6 [0x00DD4000] [0x00000800] [0x00000800] [0x00008000] [0x00100000] [0x00008000]
Payload Info : In: 262144 [65536], Out: 16384, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi
Software : , V12.0.4.0.RKGINXM [Fri May 21 03:28:37 CST 2021]
Android Ver. : 11
Patch Level : 2021-05-01
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 6.9 |