View Single Post
Old 05-29-2022, 12:18   #1307 (permalink)
Luckey1
No Life Poster
 
Luckey1's Avatar
 
Join Date: Jun 2014
Location: Infinity Box Team
Posts: 2,158
Member: 2197212
Status: Offline
Sonork: N/A
Thanks Meter: 680
Rm-1190

Operation : Write FirmWare [ v1.20 ]
Setting : UserData erase : True
Setting : LangPack Only : False

1. Make sure device is powered off. Power off, if need. Wait 10 seconds after
2. Insert USB cable in phone
Waiting for device connection ...

PTFN : Nokia USB Serial Port (COM19)
MODE : NOKIA USB SERIAL
PORT : 19
BROM : Init BROM
BROM init passed!
CHIP : MT6261 , SBID : 0xCB01 , HWVR : 0x8000 , SWVR : 0x0001
BROM : SECCFG : 0x00000005
BROM : NOKIA USB SERIAL
BROM : 0x05 BL : 0x00
BROM : MEID : FB0C9937E9CFAA96BAE9F02E38E8BB7E
BROM : Run BootLoader ...
BOOT : Run BL ver. 01
BOOT : 0x05 BL : 0x01
BOOT : WD : 0005
BOOT : RTC : Setup ...
BOOT : RTC : 000E
BOOT : PRJ : DUBAI61D.50.00.11.p1
BOOT : SWR : 50.00.11
AGENT : Look for suitable BootChain in DA ...
AGENT : DEFAULT AUTO
AGENT : Found MT6261
AGENT : DUBAI61D.50.00.11.p1
BOOT : Sending 1st DA ...
BOOT : DA sent
BOOT : Transfer control to DA ...
DA : Sync Passed!
DA : Authentification pass!
DA : Agent : v03.02 on BBID : 0x8E

NOR: 00EF : 0070 : 0016 : 0000
NOR: [Winbond] SF_W25Q32JV
NOR:
TSIZE : 0x00400000 [ 4.00 MB ]
PSIZE : 0x00400000 [ 4.00 MB ]
STYPE : 0x00000000
FLOTP : DA_NOR_OTP_EXIST

STATUS : OK
BSTYLE : SF_FLASH_BOOT

Boot done!

VPL SoftwareVersion : 50.00.11 [RM-1190]
DEV SoftwareVersion : 50.00.11
SWInfo compare result : SAME

Load FlashSet :
MROM : RM-1190_ROM_eMP_50.00.11
LANG : RM-1190_LANG_PACK_ROM_IC_eMP_50.00.11_001
CUST : RM-1190_CUSTPACK_ROM_IC_eMP_50.00.11_001
JUMP : RM-1190_JUMP_TABLE_IC_eMP_50.00.11_001
VIVA : RM-1190_VIVA_eMP_50.00.11

Prepare FlashSet :
DCR : RM-1190_ROM_eMP_50.00.11
DCR : RM-1190_LANG_PACK_ROM_IC_eMP_50.00.11_001
DCR : RM-1190_CUSTPACK_ROM_IC_eMP_50.00.11_001
DCR : RM-1190_JUMP_TABLE_IC_eMP_50.00.11_001
DCR : RM-1190_VIVA_eMP_50.00.11

Prepare Target
SDS : OK : 0x003F8000 : 0x00008000
FFS Format Ok!

Erase Target Flash
Erase done!

Write Target Flash
Write : RM-1190_ROM_eMP_50.00.11
Write : RM-1190_LANG_PACK_ROM_IC_eMP_50.00.11_001
Write : RM-1190_CUSTPACK_ROM_IC_eMP_50.00.11_001
Write : RM-1190_JUMP_TABLE_IC_eMP_50.00.11_001
Write : RM-1190_VIVA_eMP_50.00.11
Write done, waiting target response ...
Write flash done!

Verify Target FlashContent
Verify : RM-1190_ROM_eMP_50.00.11
Verify : RM-1190_LANG_PACK_ROM_IC_eMP_50.00.11_001
Verify : RM-1190_CUSTPACK_ROM_IC_eMP_50.00.11_001
Verify : RM-1190_JUMP_TABLE_IC_eMP_50.00.11_001
Verify : RM-1190_VIVA_eMP_50.00.11

Done!
Elapsed: 00:01:07

Reconnect Power/Cable!
  Reply With Quote
The Following User Says Thank You to Luckey1 For This Useful Post:
 
Page generated in 0.07668 seconds with 7 queries