GSM-Forum - View Single Post - OPPO K1 Password Reset Done without Data Loss !!EasyJTAG

.:B-A-G:. · 09-29-2022, 18:59

and same error with vccq vcc
Z3X EasyJtag Software ver. 3.7.0.24
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 04040B05853D1B89, ,FW Ver.: 01.63
Warning: CMD Pullup Level (278 mV) too low , check cables etc.!
CMD Active Level:1557 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error

09-29-2022, 18:59	#4 (permalink)
.:B-A-G:. No Life Poster Join Date: Mar 2010 Location: djerba Posts: 690 Member: 1269161 Status: Offline Thanks Meter: 119	and same error with vccq vcc Z3X EasyJtag Software ver. 3.7.0.24 Loading eMMC GEN1 Firmware... IO: 2800 mV Box S/N: 04040B05853D1B89, ,FW Ver.: 01.63 Warning: CMD Pullup Level (278 mV) too low , check cables etc.! CMD Active Level:1557 mV Box IO Level:2800 mV CLK Rate:21000 kHz Bus Width:1bit,SDR HiPower mode is off! Can't init device, Reason: CMD Timeout Error