GSM-Forum - View Single Post - Layder any solution to new exynos with anti tamper

obama2 · 03-07-2023, 11:08

HI

Layder any solution to new exynos with anti tamper THE CHIPS are installed on a047f with data line killed when phone half reads it goes dead brick

Z3X EasyJtag Software ver. 3.8.0.1
Loading eMMC GEN2 Firmware... IO: 2200 mV
Box S/N: 93E8964E6FA82E9E, ,FW Ver.: 02.53
CMD Pullup Level:2012 mV
CMD Active Level:2115 mV
Box IO Level:2200 mV
CLK Rate:24000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------

eMMC CID : 15010044563644424200CAC36AE189FF
eMMC CSD : D02701320F5903FFF6DBFFEF8E40400D
eMMC Manufacturer ID: 0015 , OEM ID: 0100
eMMC Date: 08/2006 Rev.0x0
eMMC NAME: DV6DBB , S/N: 3401804513
eMMC NAME (HEX): 445636444242
Can't init EMMC, Reason: DATA RCV Timeout Error
Check Data Line!
Done.

Can't init device, Reason: Initialization failed

03-07-2023, 11:08	#1 (permalink)
obama2 No Life Poster Join Date: Jan 2009 Location: obamas village Posts: 641 Member: 952862 Status: Offline Thanks Meter: 48	Layder any solution to new exynos with anti tamper HI Layder any solution to new exynos with anti tamper THE CHIPS are installed on a047f with data line killed when phone half reads it goes dead brick Z3X EasyJtag Software ver. 3.8.0.1 Loading eMMC GEN2 Firmware... IO: 2200 mV Box S/N: 93E8964E6FA82E9E, ,FW Ver.: 02.53 CMD Pullup Level:2012 mV CMD Active Level:2115 mV Box IO Level:2200 mV CLK Rate:24000 kHz Bus Width:1bit,SDR HiPower mode is off! ---------- eMMC Device Information ---------- eMMC CID : 15010044563644424200CAC36AE189FF eMMC CSD : D02701320F5903FFF6DBFFEF8E40400D eMMC Manufacturer ID: 0015 , OEM ID: 0100 eMMC Date: 08/2006 Rev.0x0 eMMC NAME: DV6DBB , S/N: 3401804513 eMMC NAME (HEX): 445636444242 Can't init EMMC, Reason: DATA RCV Timeout Error Check Data Line! Done. Can't init device, Reason: Initialization failed