After the process of resetting the huawei id account, the device shows the problem of "chip damage", any solution?
Code:
Welcome to Octoplus Huawei Software v.1.3.3
To enable 'Manufacture' mode dial
- for Qualcomm and Hisilicon based models: *#*#2846579#*#*
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode
- for MTK based models: *#*#14789632#*#*
ProjectMenu > Background Settings > USB Port Settings > Debug Mode
To enable 'Fastboot' mode
1. Power off the phone. Remove SD and SIM cards
2. Press 'Vol-' and insert USB cable
3. Wait until phone enters 'Fastboot' mode
To enable 'Upgrade' mode
1. Power off the phone. Remove SD and SIM cards
2. Press and hold 'Vol-' and 'Vol+' keys and insert USB cable
3. Wait until phone enters 'Upgrade mode'
Found COM ports:
1: COM16 HUAWEI USB COM 1.0
Job ID: 0000000001E2B2F4
2023-03-23 17:35:20
Starting Reset Huawei ID
Selected phone model: BLA-AL00
Searching HUAWEI USB COM 1.0 port...
Detected HUAWEI USB COM 1.0 port
Phone connect successfully
Writing XLOADER partition...
Writing UCE partition...
Writing FASTBOOT partition...
Bootloader Update successfully
Rebooting to fastboot mode...
Searching Fastboot devices...
Found android device: 5EF0218122006005
Detected Android Sooner Single ADB Interface port
Reading basic data...
Device Model: BLA-AL00
System: BLA-AL00 2.0.0.268(C00E230R1P5)
Android Version: 10
C_Version: C00
D_Version: D000
FB Lock State: UNLOCKED
User Lock State: LOCKED
Downloading resource...
Resetting Huawei ID...
Rebooting device...
Reset Huawei ID done.
Performed by 1.3.3 Software version.