View Single Post
Old 09-02-2006, 10:26   #2 (permalink)
Freak Poster
KelvinShadow's Avatar
Join Date: Sep 2005
Posts: 257
Member: 178726
Status: Offline
Thanks Meter: 69
Originally Posted by calinsuciu View Post
I have a j220i and i am trying to read the codes with USB- Smart. I use SEMC-Tool 8.7 and i am getting the error : Phone not powerd up. i have remove the battery, put the cable, pres do job, put batery back but nothing. Any solution please?

With USB-Smart it's very hard to get the phone in test-mode. If you use UFS use UFS ATRz to unlock it. Direct unlock not possible, manual unlock. (Not accepted simcard, press '*', 'left', 'left', '*')

If not using UFS, best with fully charged battery. Keep trying with power button. It's hard but, if you lucky you will get him in test-mode. So USB-Smart can read codes.

Good luck with it.

  Reply With Quote
Page generated in 0.07514 seconds with 7 queries