| Instructions:
1. power on the clip
2. power on the phone
3. connect the phone to clip
4. press unlock button one time, wait until leds are solid and press second time.
5. when the leds are solid second time, remove and put back the phone battery
6.power on the phone- you can see XXXX on scren
7. press 1 ->99->top right button under screen
8. enter 3 for unlock or 1 for security code
9. press top right button again and wait until you can see the message
,,FINISHED-PLEASE ANY KEY,, for gx20 or similar for gx10..
10. press few times top right buton to power off the phone.
2-Press 0, 1, 2, 3, top right key, 1, in sequence. The Diagnosis menu should be displayed.
3- Enter 99 and press the top right key. A message should be displayed saying Input Mode No:
4-Enter 1 and press the top right key. The following messages should appear:
· EE_FORMAT START
· EE_FORMAT OK
· EE_INIT(1) START
· EE_INIT(1) OK
· BBSRAM CLEAR END
· FINISHED
· PLEASE ANY KEY
5- Wait until all the above messages are displayed and then press the top right key.
6- Press the M key (very important). Message should display Diag Param Saving.
7- Press the red key to power down the phone
Note that you will loose ALL user data thoughy and you have to unlock the phone after also (if it has ever been locked). |