GSM-Forum - View Single Post - help with pinout for CECT KA08 mini iphone clone

shimi77 · 07-04-2009, 11:42

Here are some photos include the method I used to modify the cable , I used Samsung e700 cable .
Took LC12 connector and soldered 2,3,4 and 9 pin – I cast on the connector some hot glue to hardened it , then I connected the to some kind of array that gave me some simplicity to connect the other end of cable (e700 cable).
Again the pinout for reading the flash file is :

Rx – 3
Tx – 4
GND – 9

For flashing the phone just add the vcc + to pin 2 of the phone , vcc is the the red wire from the USB cable .

07-04-2009, 11:42	#11 (permalink)
shimi77 Junior Member Join Date: Jan 2006 Posts: 25 Member: 226402 Status: Offline Thanks Meter: 6	Here are some photos include the method I used to modify the cable , I used Samsung e700 cable . Took LC12 connector and soldered 2,3,4 and 9 pin – I cast on the connector some hot glue to hardened it , then I connected the to some kind of array that gave me some simplicity to connect the other end of cable (e700 cable). Again the pinout for reading the flash file is : Rx – 3 Tx – 4 GND – 9 For flashing the phone just add the vcc + to pin 2 of the phone , vcc is the the red wire from the USB cable .