View Single Post
Old 03-09-2011, 07:05   #5 (permalink)
starmobi
Insane Poster
 
Join Date: Oct 2010
Location: palavanthangal,chennai
Posts: 85
Member: 1409087
Status: Offline
Thanks Meter: 3
Quote:
Originally Posted by gopalhot View Post
1. find Gnd pin (it's required step, you can't continue until you will know Gnd pin location)
2. find Charge pins (it's optional step, just to save your time during future research)
3. find +Battery pins (it's optional step, just to save your time during future research)
4. connect cable Gnd to phone Gnd
5. try to connect cable Rx/Tx wires to all phone contacts one by one (except Gnd, Charge, +Battery pins) and try to read flash from phone
6. if flash read procedure can start this means that pinout found Ok and you can make other operations
--------------------------------------------------------------------------
HOW TO FIND RX .TX SIGNLES .

It is tasted and also you can test it.

1 step is, we need to find GND from phone.

2 step is, we should power on phone (operation with dead phone:
phone must be 100% dead by software)and take multimater put it to voltage.

3 multimeter (-) line put it GND and with (+) line check each connectors
, and usually Tx= 1.8v or 2.8v and Rx=1.7v or 2.7v
(it will be change by processor but strongly 1.7v or 2.8v not 3v or 4v)
This way is too easy and you will save a more time.

For example!
You have got new brand China miracle phone with USB cable. It has got
12 pin. You must find (Infinity team give good Idea 1.2.3 punkts):
1) GND usually it has got 2 GND. (now we have got 10 pins)
2) We will uncheck USB + and USB- (VSS) just with checking by USB cable (now we have 8 pins)
3) By USB cable we also uncheck V bat+, ac adaptor + polarization (now we have 7 pins)
4) Now from this 7 pins you will find 1 or 3 not used pins (last operation we have 3 or 6 pins to find Rx Tx signals)
5) Now at last operation you should use good multimeter just to find Rx Tx with 1.7v-2.7v or 1.8v-2.8v
6) WHEN PHONE IS POWERD OFF TX AND GND WITH MULTIMETER MAKING BEEEEEP
(DIOD TEST OPERATION), WHEN PHONE POWERED ON IT WILL SHOW LIKE DIOD
RESISTANS 600-700 OHM BETWIN TX AND GND.

I think I have give for every body more information’s. Just try to
find. If you find 2-3 phone signals and you will be profi mobile Tx and
Rx signals finder.
Some times you will not find with this method some phones, but why we have forum?

I'm not saying it is 100% solution but I'm saying it is TESTED solution.
I'll make some guide or FAQ by pic. if I have a free time!

This instruction will helpful for people who working in GSM repairing industry minimum 3-5 years.

*** OFFTOP. I have some friends who don't know what is it Tx and Rx
signals, and why we using device. For siemens A35,C55 and C62 they
using 3 kind of cable (because they thinking that for each brand we
must use by one by cable).

friend how to find 2pin rx tx

[email protected]
  Reply With Quote
 
Page generated in 0.09741 seconds with 7 queries