NOW ITS NOW READY TO USE FOR SPREADTRUM CHIP CHINAPHONES..
BETA TEST FOR REMOVING A USERCODE OF 6300 W/ SPREADTRUM CHIPSET:
1.Click Connect....click spreadtrum in the tab.....choose hardware type according to the spreadtrum IC....(it is indicated at the ic)...
In my case it is (SC6600L-USB)-(Manual).
3. then search the phone......(using the Inteligent port....and the usual cable....w/ modified the red alligator clip)
HERE COMES THE TRICK:...BECAUSE WHEN YOU CLICK BOOT IT WILL BE"USB NOT RECOGNIZED" AND IT WILL NOT CONTINUE TO BOOT....AND YOU CANNOT DO ANYTHING WHEN THE PHONE DOEST BOOT...
4. After you search the phone in the usaual way...using usual cable....
YOU WILL BE NEEDING....
a. 2 mini usb cables...where one usb is cut...
b. One is put in the usb port and the other one which is cut to the board.....find the pin out.....in our case...white wire is in the RX and Green wire is the TX and the black wire is the ground.....
c. Connect the 2 usb in your PC....and supply power using the modified alligator clip that comes in the package...and it will now detect by the computer.....it can now be recognized by the computer.....
and you will be needing this Drivers:
Driver.rar
install drivers
now the phone sucessfully boot
now tick user code:
try all codes.....in my case it is: 25800
now the phone is ok.....
Now let us try to format the phone.......(for testing only)
Just Click format and uncheck user define format adress
I HOPE IT WILL HELP ALL USERS HAVING PROBLEM WITH INSTALLATION AND "USB NOT RECOGNIZED WHEN BOOING THE PHONE......