GSM-Forum - View Single Post - cyclone reloaded + UFC DITS 4 , not posible to Local/Test Mode

leonirvana · 04-30-2013, 17:49

hi, i have this problem with CYCLONE RELOADED + UFC4 (DITS)

I tried nokia 1208 with fbus cable and works fine.

But trying to connect with ufc and I can not make it work. Im using DCT4-H adaptor in the right way on PCB.

I tried many ways of connection but not possible.

I use this cable to connect cyclone reaload with ufc4
http://gsmserver.es/nfs/product/8356...odo-en-uno.jpg

I set cable in Cyclone mode or Jaf mode but not work.

also I set ufc in Jaf Mode(switch 6) or none(all switches down - to numbers side) but not work. (also trying 5.1k or 7.5k)

* Sometimes i get to put in LOCAL/TEST mode, but when try to read info, always
Failed to read info -> Phone not detected
Failed to read info -> Phone not detected

04-30-2013, 17:49	#1 (permalink)
leonirvana Freak Poster Join Date: Jun 2006 Location: Argentina Posts: 261 Member: 290434 Status: Offline Sonork: - Thanks Meter: 39	cyclone reloaded + UFC DITS 4 , not posible to Local/Test Mode hi, i have this problem with CYCLONE RELOADED + UFC4 (DITS) I tried nokia 1208 with fbus cable and works fine. But trying to connect with ufc and I can not make it work. Im using DCT4-H adaptor in the right way on PCB. I tried many ways of connection but not possible. I use this cable to connect cyclone reaload with ufc4 http://gsmserver.es/nfs/product/8356...odo-en-uno.jpg I set cable in Cyclone mode or Jaf mode but not work. also I set ufc in Jaf Mode(switch 6) or none(all switches down - to numbers side) but not work. (also trying 5.1k or 7.5k) * Sometimes i get to put in LOCAL/TEST mode, but when try to read info, always Failed to read info -> Phone not detected Failed to read info -> Phone not detected Last edited by leonirvana; 04-30-2013 at 17:58.