GSM-Forum - HUAWEI DUB-LX1 Writing Board Software Successfully With OCOTOPUS HUAWEI TOOL

Welcome to Octoplus Huawei Software v.‪1.2.4‬

To enable 'Manufacture' mode dial
- for Qualcomm and Hisilicon based models: *#*#2846579#*#*
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode
- for MTK based models: *#*#14789632#*#*
ProjectMenu > Background Settings > USB Port Settings > Debug Mode

To enable 'Fastboot' mode
1. Power off the phone. Remove SD and SIM cards
2. Press 'Vol-' and insert USB cable
3. Wait until phone enters 'Fastboot' mode

To enable 'Upgrade' mode
1. Power off the phone. Remove SD and SIM cards
2. Press and hold 'Vol-' and 'Vol+' keys and insert USB cable
3. Wait until phone enters 'Upgrade mode'

Found COM ports:
1: COM10 USB Serial Port

Sending an authorization request...
Analyzing Smart Card...
Authorized.

Selected rawprogram file: C:/Users/Ali/Downloads/Compressed/Board_DUB-LX1_8.1.0_143_(185)/Board_DUB-LX1_8.1.0_143_(185)/rawprogram0.xml
Selected patch file: C:/Users/Ali/Downloads/Compressed/Board_DUB-LX1_8.1.0_143_(185)/Board_DUB-LX1_8.1.0_143_(185)/patch0.xml
Selected firehose file: C:/Users/Ali/Downloads/Compressed/Board_DUB-LX1_8.1.0_143_(185)/Board_DUB-LX1_8.1.0_143_(185)/prog_emmc_firehose.mbn
Selected Partial flashing mode!

Job ID: 0000000000A0CDF9
2021-02-23 14:48:12 GMT -------------------------------------------------
Starting Write Firmware(Factory mode)
Selected phone model: ‪DUB-LX1‬
Warning: Please, before firmware write, disconnect all other devices from the computer (including phones, modems, etc.) and close all other running programs. To avoid errors in the flashing process, use a clean PC (without any installed drivers for other Android-based devices). Dont run any other programs or attach new devices to your computer during the flashing procedure! Don’t turn off phone and don’t disconnect cable during firmware write. Please, follow these simple instructions to avoid phone damage
Connecting to phone..
Please, reconnect battery, connect USB cable with attached Test Point on your phone!
Sending loader prog_emmc_firehose.mbn...
Loader send successfully
Reconnecting, please wait..
Writing. Please wait...
Writing RPM partition...
Writing TZ partition...
Writing SBL1 partition...
Writing APDP partition...
Writing MSADP partition...
Writing KEYMASTER partition...
Writing DEVCFG partition...
Writing ABOOT partition...
Writing MODEM partition...
Writing KERNEL partition...
Writing RAMDISK partition...
Writing RECOVERY_RAMDISK partition...
Writing RECOVERY_VENDOR partition...
Writing ERECOVERY_KERNEL partition...
Writing ERECOVERY_RAMDISK partition...
Writing ERECOVERY_VENDOR partition...
Writing SYSTEM partition...
Writing CACHE partition...
Writing ODM partition...
Writing VENDOR partition...
Writing PRODUCT partition...
Writing USERDATA partition...
Writing GPT_MAIN0 partition...
Writing GPT_BACK0 partition...
Patching. Please wait...
Patch done successfully

Write Firmware(Factory mode) done.
Performed by ‪1.2.4‬ Software version.