MTK load manual files [Answered]
 

I load scatter but now i want to load manuall files like system and userdate ..


how can i select it and give path.


https://forum.gsmhosting.com/vbb/att...1&d=1642170552

Hello. Put files in folder with scatter and press restore from backup.

Selected model: Huawei AMN-LX9 (Y5 2019)
Operation: Restore From Backup
Software version: 2.10

Host Power Off... OK
Switch virtual port to USB... OK
Connect Type-C to BOX... OK
Host Power On... OK
Connect phone to BOX in BROM mode
Wait for device... OK
Read usbhost speed... HIGH
Read Device Descriptor...
Get VID/PID...0E8D/0003
Send start cmd... OK
Get HW code from device... 0766
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6765]
Get sec config... OK [000000E5]
Active sec flags: [SBC DAA]
Advanced Bypass Security... OK
Disconnect virtual port... OK
Connect Type-C to HUB... OK
Wait for device connecting... OK
Driver: [MediaTek Inc.,wdm_usb,MediaTek USB Port,usb2ser.sys,3.0.1504.0]
Device found at COM7 [BROM]
Open port... OK
Send start cmd... OK
Get HW code from device... 0766
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6765]
Library Version [2]
Select platform... OK
Init BROM... OK
Force Charge... OK
Disable WatchDog Timer... OK
Reopen port for libver2... OK
Get ME ID... OK
ME_ID = 0xD41F62D0, 0xFFF9E211, 0xA01C304D, 0xB5932702
Get Chip ID... [MT6765]
Get SOC ID... [C8F5566655E161E0FFB0E755FB06B76B5DB960740CD8689CBB 9DD619041DCA3F]
Get sec config... OK [000000E0]
Load DownloadAgent... OK
Search DA... OK [23]
Send preloader... OK
Start preloader... OK
Check preloader answer... OK
Send bootloader... OK
Start bootloader... OK
Wait for answer from bootloader... OK
Send SYNC signal... OK
Setup device enviroment... OK
Setup device parametres... OK
Receive DA SYNC signal... error(1)

Try to svitch battery mode.

Thanks for the quick response sir.

I really appreciate your support.

Dear Sir is there any way to select files manually like sp flash tool or like in cm2.

In those software we can load any parts from different paths.

We note this option and will add in future updates.