BE4 repair, reboot and auto power off? Hi I hope someone in this forum has come across a problem on the BE4 the phone reboots, auto power off, sometimes switches on, sometimes switches on but with no display or lights. Has anyone come across such a fault and has some sought of a soltuion plz help me out. it is version 138 amd 2mb. hope someone can help regards reo |
Alcatel Tool Box 1.017 by Emsi Use Alcatel ToolBox 1.017 by EMSI, It is not free. |
I have this problem too. I tryed Flash Be4 Amd2Mb 136 phone with other 15flashes (some sw) but, no result :-( Phone is crayzy. May be i can repair first flash area with hex editor ?, how do this correctly? :( |
Sorry for you but this is an HARD problem. try to rehot the ic power bga.;) |
how i can read/write dump from flash ? To: Pandemonio100 This is not hardware problem Problem in first bytes in flash;) |
hi now that we no it is in the first bytes of the flash how can we repair it ? does anyone no ? or is an upgrade the only way to repair this. regards reo |
One of my friend work in ALCATEL SERVICE CENTER and he have told me that this is an hard problem and he have resolved many many many 3xx resolding the ic power. ;) |
I have software for repair all software problems (work withou dongle) I exchange it for Pemaster 2.04 (also without dongle) for unlock and flash motorola phones with RoEMMI Peter [email protected] |
resold only or replace it Resold only or replace it ? where to find this component ? |
I don't have board in this moment to look the name of component but i remember that is type GCAPII in motorola phones, resold it if you have infrared solder machine, if not desolder the ic reball it and resold on the board. For GSMZONESK please give the name of your fantastic program or put here the screeshot. ;) |
.... site ... |
Pandemio: Alcatel ToolBox by EMSI v. 1.017 Full can reapir all software errors (after wrong unlock, or bad flashing) works 101% MadMan GSMZone Slovakia |
ho sure that can repair all software error but i think the problem is ic 10 on figure www.inside-gsm.com ;) P.s. : only for statistic i have sent in Alcatel service center one phone 303 whit same problem of REO, it had the guarantee and i don't have open it. When the phone is returned repaired, i have open it and I have tried to see if had been made soldering. Under one IC Bga there was a lot of flux....number 10 on figure. is it a case only?;) |
the ic is PTWL2212 :) |
Yessssss.;) |
All times are GMT +1. The time now is 15:24. |
vBulletin Optimisation provided by
vB Optimise (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.
- GSM Hosting Ltd. - 1999-2023 -