6110 DSP3 eeprom needed ...
 

Please, would someone be so great to send me a 6110 DSP3 EEPROM (the best would be from SW 4.05 or 5.38, but you can send any DSP 3)to the following e -mail address:

[email protected]

I upgraded my 6110 from 4.05 to 5.38, use nk_calc by Dejan and I've got 4 locks closed. Now, if I flash the phone back to 4.05 then it does not display anything (just the LEDs are glowing) and can not be repaired using the nk_calc.

Thanx a lot, people!!!

joey.:confused:

Hi!

exactly the same problem by me! It was not the same version on my 6110 but that doesn't matters!

So any solution or an eeprom to => [email protected]

thanks, igi

Hi.
EEPROM file is not a solution to your problems.
(EEPROM+DSP+Processor version - goes together).
I repaired 2 pieces by logging with "Nworkshop_dct3" send the "nk_phone.log" file to someone to calculate and give you "nk_phone.set" file and afther that upload info in phone...

Best Regards.

Hi!

I know that via log file the eeprom could be repaired, but who will calculate this here? :(


cu - igi